Product Description
Eastman 2380 Turbine Oil (Quart)
Eastman Turbo Oil 2380 is a 5 cSt synthetic lubricant that is approved against US military specification MIL-PRF-23699F-STD, and UK specification DEF STAN 91-101/2 (replaced DERD 2499). This lubricant provides a balanced combination of thermal and oxidation stability, load carrying capacity, lower volatility and has the best low temperature flow characteristics of all 5 cSt turbine oils. BP Turbo Oil 2380 is recommended for the lubrication of most aircraft gas turbines and accessories. It is also recommended for the lubrication of aero-derived gas turbines in industrial power generation, offshore and marine applications. BPTO 2380 has been approved by a wide range of engine and accessory manufacturers for their applicable equipment, including: Rolls Royce Ltd, Allison, GE, Pratt & Whitney, Pratt & Whitney Canada, Honeywell, Hamilton Sundstrand, CFMI, IAE, MTU, Solar and Turbomeca, etc. Viscosity: BP Turbo Oil 2380 has the best low temperature viscosity characteristics among all 5 cSt oils. Cleanliness: Minimum formation of varnish and sludge deposits over long periods of use. Seal Material Compatibility: Very benign to commonly used seal materials in gas turbines. Load Carrying Capacity: BP Turbo Oil 2380 is among the best of its class and provides excellent protection to bearings, gears, and other highly loaded lubricated surfaces. Bulk Stability: Its high degree of oxidation resistance permits a long period of operation without significant increase in viscosity and/or total acidity.
This oil was formerly called BP2380
Save on Oil filters! Click here for Champion and Tempest Oil Filters
Typical Properties | ||||
Property | Test Method |
Typical Value, Units | ||
Density @ 15°C | ASTM D 1298 | 0.9749 kg/L | ||
Viscosity, Kinematic | ||||
|
ASTM D 445 | 4.97 mm2/s | ||
|
ASTM D 445 | 24.2 mm2/s | ||
|
ASTM D 2532 | 7,950 mm2/s | ||
Pour Point | ASTM D 97 | -57°C | ||
Flash Point | ASTM D 92 | 265°C | ||
Total Acid Number | SAE ARP5088 | 0.43 mg KOH/g | ||
Evaporation Loss 6.5 hrs @ 204°C | ASTM D 972 | 3.0% | ||
Foaming Volume | ||||
|
ASTM D 892 | 9/0 ml/vol | ||
|
ASTM D 892 | 8/0 ml/vol | ||
|
ASTM D 892 | 8/0 ml/vol | ||
Load Carrying Ability a | ||||
|
IP 166 | 99% | ||
|
IP 166 | 86% | ||
Rubber Swell | ||||
|
DERD Test, Method 4 | 10.5% | ||
|
DERD Test, Method 4 | 22.5% | ||
|
DERD Test, Method 4 | 10.5% | ||
|
DERD Test, Method 4 | 14% |